Threading Film; Decaling - Royal Sovereign RSC-1401C Series Owner's Manual

11.1. Decaling

1. Turn the power switch on ("I" position). The Power switch is
located on the rear left side of the unit.
2. Complete the steps as in the "LOADING FILM" section (see page
10).
3. Set the top roller to the desired temperature (RSC-1401H)
4. Take off the Frame-Paper Guide and the Feed Table.
5. Pull the top film down over the Safety Cover to the bottom of the
craft paper/mounting film.
6. Align and center the craft paper/mounting film to the top film and
tighten the two lower core screws (Figure 1).
7. Thread the top film underneath the Upper Idle Bar.(Figure 2)
8. Tape the top film on to the Release Liner Take-Up.(Figure 2)

11. THREADING FILM

10
RSC-1401C/H SERIES
Figure 1
Figure 2