Programming The Unit - Krups KM8105 Manual

cafetie?re lafayette KM 810.qxd:KM 8005 franc% a is - copie.qxd
Warning
- Put the carafe or thermal jug (h) on its plate/base (g) within a maximum of
20 seconds. Hot water continues to drip in the filter holder (c) when the carafe
(h) is removed. The overflow of coffee and hot water could cause burns.
- Do not exceed the maximum capacity of the water tank (a) as shown by the Maxi
level written on the water tank.
- Place the ground coffee into the paper filter or directly into a permanent filter. After
use, discard the grounds, and rinse the cone filter holder (c) under running water.
- When the machine is hot, do not touch the drawer as the surface may be hot.
Use the drawer handle.

PROGRAMMING THE UNIT

1 - Adjusting the Time
• Set the clock time by pressing the « h » and « min » buttons (p). To switch between
"AM/PM" and 24 hour mode press simultaneously "h" and "min" buttons.
2 - Auto-On setting
• The machine must be in stand by mode, i.e. power on and default time is displayed.
Press the Program button (o) once, « program » is displayed steady and "9:99"
•
blinks on display (l).
• Press the « H » and « min » buttons (p) to set a time for the machine to brew
automatically.
Press the Program button (o) when done. If no button are pressed for several
•
seconds the programmed start time will be accepted automatically and the display
will return to stand by mode showing the real time clock.
g. 6
After programming the automatic start time as described above, be sure to prepare the
machine for a brew cycle with water in the tank, coffee in the brew basket and carafe
securely in place.
Press Auto-On button (n), the machine will brew automatically at the desired time. You
can check preset time by pressing the Program button (o). The program will need to be
activated when needed again.
10
29/04/09 15:07 Page 10
English