Honeywell HUS-NVR-1032/6032-E User Manual page 46

System Operation and Configuration
38
Configuring a Camera
To configure the camera stream (Codec Type, Resolution, Frame Rate and Bit Rate), right
click the icon of the camera and select "Camera Configuration" in the pop-up menu, the
configuration window is shown as the following figure:
Figure 5-17 Camera Configuration
When the settings are finished, click Apply to save the new configuration and click Cancel
to close the window.
Removing a Camera
Select a camera by clicking its icon in the "Devices" list and click
corner; or right click the icon of the target camera and select "Remove" in the pop-up menu.
Playing Live Video
Select a video window on the Live screen and then right click the icon of the target
camera in the "Devices" list and select "Live" in the pop-up menu;
Drag the icon of the target camera to the designated video window.
Play back Video
Select a video window on the Live screen and then right click the icon of the target camera
in the "Devices" list and select "Playback" in the pop-up menu
Manual Recording
On the Live screen, you can manually start/stop recording on a camera.
Start Manual Recording Right click the icon of the camera and select Record Manual
Recording.
Stop Manual Recording Right click the icon of the camera and select Record Stop
Recording.
Panic Recording
When a panic or duress condition occurs, you can start panic recording by using one button
or key. When panic recording is started, all the connected IP cameras start recording.
Perform one of the following two methods to start and stop the panic recording:
in the bottom right