Cleaning The Water Tank - DeLonghi EC9335.M Manual

flow the edge and damage the appliance, the surface it rests on or
the surrounding area.
1. Remove the drip tray (fig. 33).
2. Remove the cup grille (A11), drip tray grille (A12) and level
indicator (A14), empty the water and clean all the compo-
nents with a cloth, then reassemble the drip tray.
3. Put the drip tray back in place.
13.3 Cleaning the espresso cup grille
1. Extract the grille (A10) by pulling it from the left, then re-
moving it from the support (fig. 34).
2. Clean the support with a cloth and wash the grille (dish-
washer safe).
3. Put the grille back on the support from the right side, then
push until it is correctly attached (fig. 35).
2
1
34
13.4 Coffee filter cleaning and maintenance
The coffee filters are designed to obtain the best possible coffee
froth. For best results, the filters must always be clean and free
from all coffee residues.
After using the appliance, always rinse the filters under abun-
dant running water (fig. 36), pushing the perforated filter to
make sure it is always correctly inserted in its housing (fig. 37);
make sure the hole underneath (shown in fig. 40) is free from
all residues.
2 2 2
36
If still dirty, and in any case always at least once a month, clean
the coffee filters thoroughly:
1. Extract the perforated filter by pulling the tab (fig. 38).
1 1
35
13.5 Cleaning the boiler outlet
After every 200 coffees, rinse the boiler outlet. Press the
rinse button (B4) and deliver about 200 ml of water.

13.6 Cleaning the water tank

1. Remove the filter (*if present) and rinse with running
water.
2. Clean the water tank regularly (about once a month) and when-
ever you replace the water softener filter (C6) (*if present) with
a damp cloth and a little mild washing up liquid, then rinse
thoroughly.
3. Replace the filter (*if present), fill the tank with fresh water
and replace the tank.
4. (Models with water softener filter only) Deliver about 100
ml of water.
Danger!
While cleaning, never immerse the coffee maker in water. It is an
electrical appliance.
37
35
38
2. Rinse the filters under run-
ning water (fig. 39).
3. Make sure the holes are
not blocked. If necessary,
clean with a pin (fig.
39-40).
4. Dry all the components
with a cloth.
5. Put the perforated filter
back in the housing and
press as far as it will go
(fig. 37).
40
39