Default Values - DeLonghi EC9335.M Manual

Button
4. Press the button (B1) to exit the menu. (If the appliance
is left idle for about 1 minute, it exits automatically from
the settings menu and is ready for use again).

12.4 Default values

The appliance can be reset to the default values. Proceed as
follows:
1. Press and hold the
least 3 seconds to access the menu;
2. Press and hold the
corresponding light starts flashing;
3. Press the button (B1) to exit the menu. (If the appliance
is left idle for about 1 minute, it exits automatically from
the settings menu and is ready for use again).
12.5 Energy saving
Use this function to enable or disable energy saving. When en-
abled, the function reduces energy consumption in compliance
with European regulations.
Proceed as follows:
1. Press and hold the
least 3 seconds to access the menu;
2. Press the button (B6). The light (B12) comes on ;
3. Press the button (B1) to exit the menu. (If the appliance
is left idle for about 1 minute, it exits automatically from
the settings menu and is ready for use again).
Please note:
• If energy saving is active, you may have to wait a few seconds before delivery.
• When energy saving is disabled, steam is delivered immediately.
12.6 Extra grinding adjustment
Over time, the burrs will wear down and the quantity of ground
coffee will diminish. When adjusting the burrs as described in
section "4.5 Adjusting the quantity of ground coffee in the fil-
ter" is no longer enough, you can select a new grinding range.
Proceed as follows:
1. Press and hold the
least 3 seconds to access the menu. The
(B16) lights alternate;
2. Turn the mode selection dial (B8) to the
light (B14) remains on steadily;
3. Select the new grinding range by pressing the
(B4);
Time
9 minutes
1.5 hours
3 hours
(B3) and (B7) buttons for at
button for a few seconds until the
(B3) and (B7) buttons for at
(B3) and (B7) buttons for at
(B15) and
position. The
4. Press the
ance is left idle for about 1 minute, it exits automatically
from the settings menu and is ready for use again);
5. Turn the ground coffee quantity dial (B2) to the
position, then proceed to adjust as if it were the first time
("4.5 Adjusting the quantity of ground coffee in the filter").
13. CLEANING
13.1 Cleaning the machine
The following parts of the machine must be cleaned regularly:
- drip tray (A13) complete with cup grille (A11) and drip tray
grille (A12);
- espresso cup grille (A10);
- coffee filters (C2) and (C3);
- the beans container (A2);
- the coffee mill burrs;
- the coffee mill outlet (A22) (smart tamping station);
- boiler outlet (A21);
- water tank (A17);
- cappuccino maker (A8) as described in section "10. Clean-
ing the cappuccino maker after use".
Important!
• Do not use solvents, abrasive detergents or alcohol to clean
the coffee machine.
• Do not use metal objects to remove encrustations or coffee
deposits as they could scratch metal or plastic surfaces.
• None of the components of the appliance can be washed in
a dishwasher with the exception of the drip tray (A13) and
cup grilles (A10) and (A11).
• If the appliance is not used for more than a week, before
using it again, we recommend you perform a rinse cycle as
described in section "3. Setting up the appliance".
Danger!
• While cleaning, never immerse the coffee maker in water. It
is an electrical appliance.
• Before cleaning the outside of the appliance, turn it off,
button
34
button (B1) to exit the menu. (If the appli-
unplug from the mains socket
and allow to cool.
13.2 Cleaning the drip
tray
The drip tray is fitted with a
level indicator (A14) showing
the amount of water it contains.
Before the indicator protrudes
from the cup tray, the drip tray
must be emptied and cleaned,
otherwise the water may over-
33
"min"