Lpg Safety Information - Beef Eater 1600 Series Assembly And Operating Instructions Manual

LPG SAFETY INFORMATION

LPG safety information
• Use only gas cylinders, which meet national and
regional codes. The minimum cylinder size for this
barbecue is 6kg. Ensure that the cylinder can provide
enough fuel to operate the appliance. If in doubt, check
with your local gas supplier.
• Pay attention that when changing the gas cylinder which
shall be carried our away from any source of ignition.
• Never connect a cylinder, which does not meet
local codes.
• All cylinders 7kg or larger that do not sit in the location
provided inside the trolley must be placed on the ground
at the rear of the barbecue.
• Cylinders smaller than 7Kg (maximum size 465mm
high x 306mm wide) may be placed on the hook on the
right side of the barbecue.
• The isolation valve must be turned off when the
appliance is not in use.
• Gas cylinders must be stored in an approved housing out
of reach of children.
• When disconnecting the gas bottle ensure that all the
control valves are in the 'OFF' position.
• When reconnecting the hose to the bottle, ensure that
all connections are tight before replacing in storage
compartment.
• Carry out a leakage check as detailed below after each
reconnection.
• Only regulator which complies with EN 16129
can be used.
• The length of hose cannot exceed 1.5m. In Finland, the
length of hose cannot exceed 1.2m.
• It's necessary to change the flexible tube when the
national conditions require it, and/or depending on
its validity.
• Make sure that the flexible tube is not subjected to
twisting when the appliance is in operation.
7
LPG SAFETY