Copy Value Block - Elatec TWN3 Multi ISO Technical Manual

7.4.4.5 Copy Value Block '='

Use this command to copy a value block to another value block of the same sector. A read after copy
is performed automatically. The command fails if one of the specified blocks is not in value format. You
must log into the respective sector before this command can be executed.
Command: '=[SourceBlock][TargetBlock]'
Parameters Description
[SourceBlock]
Source block address (1 byte)
[TargetBlock]
Target block address (1 byte)
Answer
Answer Description
Data<CR><LF>
New value of target block
'F<CR><LF>'
Error: general failure
'I<CR><LF>'
Error: invalid block format
Examples
Command Description
=0809
Copy value block 08 to block 09
=080A
Copy value block 08 to block 0A
Elatec GmbH
Page 35 of 65