Replacing The Batteries - tibelec 975530 Instructions Manual

Replacing the batteries

Iif the 12V LED flashes 5 times, the batteries are worn out and must be replaced.
To do this, loosen the screw, install the 2 batteries (LR44 1,5V) , respecting the pola-
rity, and tighten again.
The consumer is obliged by law to recycle all used batteries and accumulators.
It is forbidden to throw them in the ordinary bin! Refer to the environmental
protection details.
Storage and maintenance
Storage of the test plunger on the back of
the device (see illustration opposite).
Clean the tester with a soft, slightly damp
cloth; do not use abrasive or solvent products.
Technical specifications
• Can be used for frequencies ranging from 50Hz to 60Hz
• Operating temperature : -10°C ~ 55°C
• Size and weight : 37x50x220mm / 134gr
• Safety standard : CAT III
• IP 54: equipment protected against dust deposits and water splashes from all
directions.
Certified in accordance with
European standards
Risks resulting from
hazardous voltages
Class II equipment without
ground connection
8
:
:
:
Do not dispose of appliances
bearing this symbol with
domestic waste. Use a suitable
collection point.