tibelec 975530 Instructions Manual page 6

IMPORTANT: these instructions are for your safety.
GB
Read them carefully before use and keep them for
future use.
Warning :
1. Be particularly careful when using voltages above 30V AC (RMS) or 60V DC to
avoid damage or electric shock.
2. Never apply an input voltage higher than the maximum value of the range allowed
by the device manufacturer. This monitor is designed for low voltage applications
(400V MAXI EN ALTERNATIF/CONTINU).
3. Never use the tester to measure the line feeding a device that generates a sudden
surge in voltage as it may exceed the maximum permitted voltage (e. g. motors).
4. This device is designed for contact testing only. Do not keep continuous contact
for more than 30 seconds, especially on high voltage conductive parts.
5. Test known live circuits to familiarise yourself with the device.
6. Never use the tester if the test plungers or leads are damaged or broken. Make
sure they are never wet or damp; check that the tester and the leads are working
properly before commissioning.
7. Opening the housing gives access to parts that hazardous voltage conductive
parts. Any action on internal circuits could result in hazardous use. Never use the
disassembled tester. Before using your tester: check that the housing is properly
closed.
8. Always make sure your fingers are behind the test plunger guard during measure
ments. During the measurement, be careful not to come into direct or indirect
contact (e. g. with fingers) with high voltage conductive parts.
Description :
1
6
2
3
1. LED indicators
2. Main test plunger positive
3. Test plunger negative