Table of Contents
Advertisement
Data Rate
N Data Rate
Channel Width
Preamble Type
CTS Protect
Tx Power
Tx power works in conjunction with the switch on the side of
the device. The switch is the primary setting and the Tx
power value here will be a percentage of the slide switch
setting. E.G If the slide switch is set to Green Mode (25%) and
Tx power to 75%, the overall output will be 75% of 25%.
Set the wireless data transfer rate. The
default is set to Auto.
Set the data rate of 802.11n. The default is
set to Auto.
Select wireless channel width (bandwidth
used by wireless signals from the device) –
the recommended value is Auto 20/40MHz.
Set the wireless radio preamble type. The
default value is "Short Preamble".
Enabling this setting will reduce the chance
of radio signal collisions between 802.11b
and 802.11g wireless access points. It's
recommended to set this option to "Auto".
Set the power output of the wireless radio.
You may not require 100% output power.
Setting a lower power output can enhance
security since potentially malicious/unknown
users in distant areas will not be able to
access your signal.
Advertisement
Table of Contents
