Resetting The Unit; Care And Maintenance - Jensen JBD-100A User Manual

If the unit experiences a power surge or electric shock, it is possible that the internal
micro-controller may lock up and the unit will not respond to any commands from the
panel controls. In this event, use a straightened paper clip, toothpick or similar objects
to press the RESET button located at rear of the unit (see the below figure). The
reset operation clears the system memory and all of your previous settings will be
erased.
CAUTION: DO NOT USE A SHARP OR POINTED OBJECT TO PRESS THE
RESET BUTTON. IT MAY DAMAGE THE RESET SWITCH INSIDE THE UNIT.
RESET BUTTON
1. Do not subject the unit to excessive force, shock, dust or extreme temperature.
2. Do not tamper the internal components of the unit.
3. Clean your unit with a dry cloth. Solvent or detergent should never be used.
4. Avoid leaving your unit in direct sunlight or in hot, humid or dusty places.
5. Keep your unit away from heating appliances and sources of electrical noise such
as fluorescent lamps or motors.
CLEANING THE UNIT
•
To prevent fire or shock hazard, disconnect your unit from the AC power source
when cleaning.
•
The finish on the unit may be cleaned with a dust cloth and cared for as other
furniture, Use caution when cleaning and wiping the plastic parts.
•
If the cabinet becomes dusty wipe it with a soft dry dust cloth. Do not use any wax
or polish sprays on the cabinet.
•
If the front panel becomes dirty or smudged with fingerprints it may be cleaned
with a soft cloth slightly dampened with a mild soap and water solution. Never use
abrasive cloths or polishes as these will damage the finish of your unit.
CAUTION: Never allow any water or other liquids to get inside the unit while cleaning.

RESETTING THE UNIT

CARE AND MAINTENANCE

E-12