Setting Up A Wireless Alarm Network - Kidde P4010ACS-WCA User Manual

At any time during wireless alarm network setup, if you have a problem, you can push and hold
note:
the Test/Hush button on any problem unit until you hear three (3) beeps (approx 8 sec), and then release
the button. The unit will reset the unit's wireless settings (described in Section 9.3). Once wireless network
settings are reset, the unit will prompt the user to follow Quickstart instructions.

9.1 Setting Up a Wireless Alarm Network

Creating an interconnected wireless alarm network is a simple process, with intelligent "self-enrollment"
features, and user-friendly voice prompts.
a. reMoVe aLL deViceS FroM tHeir packaGinG
b. poWer Up aLL deViceS
•
Locate the red wheel on the back of the device. Turn the red wheel to the "ON" position on ALL devices
using the white tool included with the Quick Start Guide.
•
Once powered, the light rings will glow red and voice message will announce, "Ready to connect. Follow
Quick Start instructions."
c. LanGUaGe SeLection
•
This unit operates in either English or French. To switch your language preference at any time, press the Test
button twice on ALL devices you wish to connect. You should hear one beep for each button press, followed
by a voice message confirming your language selection ("English language selected" or "Langue française
selectionné"). If no language is selected, the voice prompts will continue in the default / set language.
If no further steps are taken within 15 minutes of initial power up, a voice prompt, "No devices
note:
found, not connected" will be heard once, and the wireless function will turn off. The unit will then
perform as a standard hardwired alarm. See Section 9.3 for re-activating wireless.
13