Setting Up A Wireless Alarm Network - Kidde P4010DCS-W User Manual

9.1 Setting Up a Wireless Alarm Network

Creating an interconnected wireless alarm network is a simple process, with intelligent "self-enrollment" features, and
user-friendly voice prompts.
A. remoVe All deVIceS from theIr pAcKAgIng
b. poWer Up All deVIceS
•
Locate the red wheel on the back of the device. Turn the red wheel to
the "ON" position on ALL devices using the white tool included with the
Quick Start Guide.
•
Once powered, the light rings will glow red and voice message will
announce, "Ready to connect. Follow Quick Start instructions."
note: If no further steps are taken within 15 minutes of initial power up, a voice prompt, "No devices found, not
connected" will be heard once, and the wireless function will turn off. The unit will then perform as a standard stand
alone alarm. See Section 9.3 for re-activating wireless.
c. pIcK one deVIce
Press and hold the button on only ONE device until you hear two beeps.
Release button. You will hear "Searching for other devices".
•
The light will pulse and device will sound a continuous "Sonar" ping until
step E is complete.
14
ACTIVATION
TOOL
Figure 9.1-B
"Searching for
other devices."
Hold for DON'T press buttons
5 seconds on other devices
Figure 9.1-C