Table of Contents
Advertisement
ELECTRICAL
DANGER
Serious electrocultion hazard. Electrical
!
grounding is required. This appliance is equipped with a
3-prong (grounding) polarizing plug for your protection against
possible shock hazards. Failure to comply with these electrical
guidelines may result in possible death or serious injury, fire or
loss of property.
WARNING
Never use an extension cord to connect unit
to electrical source. Do not use a two-prong adapter or remove
the power cord grounding prong.
Installation must comply with all applicable electrical codes.
The electrical supply must be located within the shaded area
of the illustration below. A separate circuit, servicing only this
appliance, is required. A ground fault circuit interrupter (GFCI)
is not recommended and may cause interruption of operation.
The outlet should be placed in the hatched area dimensioned
below.
Electrical Supply
Service
Power/Cord Type/ Length
PLACEMENT
CAUTION
Before moving unit into position, secure the
door closed and protect any finished flooring.
Use an appliance dolly to move the unit near the opening.
6 | perlick.com/residential
PERLICK RESIDENTIAL COLUMN REFRIGERATION INSTALLATION INSTRUCTIONS
ELECTRICAL / ANTI-TIP BRACKET / PRODUCT PLACEMENT
115V, 60 Hz., Phase 2, 3.3 amps
Dedicated 15 amp circuit
NEMA 5-15P w/5' power cord
ANTI-TIP BRACKET
WARNING
To prevent the unit from tipping forward,
the anti-tip bracket must be installed. Use all anti-tip bracket
hardware as instructed. Level as instructed on page 7 prior to
installing anti-tip bracket(s)
The anti-tip bracket and supporting hardware is included with
your unit. Please note that four anti-tip brackets are required
for each unit or dual installation. In the case of dual installation,
each individual unit must be outfitted with the two anti-tip
brackets on cabinet sides for a total of four.
For drawings of the anti-tip bracket installation on integrated
(built-in) units, see page 8. For drawings of the anti-tip bracket
installation on freestanding units, see page 9.
WARNING
Verify there are no electrical wires or
plumbing in the area which the screws could penetrate.
CAUTION
Always wear safety glasses and use other
necessary protective devices or apparel when installing or
working with anchors. Anchors are not recommended for use in
lightweight masonry material such as block or brick, or for use
in new concrete which has not had sufficient time to cure. The
use of core drills is not recommended to drill holes for anchors.
90° HINGE STOP
Perlick column doors open to 105°. When installing a panel
thicker than ¾" (19), or if located next to adjacent wall, the 90°
hinge stop pin may be required to prevent damage to the unit
and adjacent cabinetry/walls. This hinge pin must be installed
prior to full integration.
1. Remove the cabinet hinge trim cover by removing the
three Phillips head fasteners located on the top of the
cabinet. Lift the rear of trim cover to tilt trim cover to
disengage tab on right and left end of trim cover. Slide
forward to remove.
2. Open cabinet door approximately 45° to 85° to expose hole
under hinge guard. Install hinge pin into hole. Ensure hinge
pin is fully seated to top of hinge to prevent damage to
hinge guard.
3. Reattach the cabinet hinge trim piece. Slide front bottom
of hinge trim cover under reed switch. Tilt trim cover to
engage right and left end tab into cabinet. Install the three
fasteners.
Advertisement
Table of Contents
