3.7
Device Configuration
In Device Configuration page, you can do the following:
Set time zone.
Select whether to enable direct link mode, and IMU sensor data output.
Set 5-pin serial port baud rate.
Select whether to enable speaker (smart voice broadcast).
Select whether to enable base alert.
Select whether to enable device debug.
Select whether the power is on automatically when 5-pin cable is connected.
Select whether the power is off automatically when 5-pin cable is disconnected.
Select whether to enable network.
Select whether to enable WIFI hotspot share network: with a SIM card inserted and
it enabled, the device connected to the hotspot of the receiver (PC, smart phone or
tablet) can surf the internet by using SIM data.
Set naming method of static files.
Select whether to enable base transmission site info.
12
SHANGHAI ESURVEY GNSS CO., LTD.