Removing The Keyboard - Clevo W253CZQ Service Manual

Removing the Keyboard

1. Turn off the computer, and remove the battery
2. Remove screws - from the bottom of the computer. Press at points
1 2
(you may need to use the Eject Pin Tool to do this
3. Remove the LED cover module
4. Carefully lift the keyboard up, being careful not to bend the keyboard ribbon cable
ribbon cable from the locking collar socket
10
5. Carefully lift up the keyboard
a.
3
1
b.
5
6
(page 2 - 5).
(Figure 9a).
and screws - from the keyboard
5 9
4
(Figure 9c)
11
(Figure 9d) off the computer.
12
c.
3
2
7
9
8
4
to unsnap the LED cover module
3
(Figure 9b).
. Disconnect the keyboard
10
10
11
d.
12
Keyboard Tabs
Disassembly
Figure 9
Keyboard Removal
a. Remove screws from the
4
bottom of the computer.
Press at points 3 to un-
snap the LED cover
module.
b. Remove the LED cover
module and screws
from the keyboard.
c. Carefully lift the key-
board up and disconnect
the keyboard ribbon ca-
ble from the locking col-
lar socket.
d. Remove the keyboard.

Re-Inserting the
Keyboard
When re-inserting the
keyboard firstly align the
four keyboard tabs at the
bottom (Figure 9c) at the
bottom of the keyboard
with the slots in the case.

4. LED Cover Module
12. Keyboard
• 7 Screws
Removing the Keyboard 2 - 13