Tspl Command Set - Tally Dascom DL-830 User Manual

Tally Dascom DL-830

9.3 TSPL Command Set

Commands
SIZE
BLINE
BARCODE
QRCODE
GAP
REFERENCE
SPEED
DENSITY
SET PEEL
SET CUTTER
SET
PARTIAL_CUT
TER
SET TEAR
SET RIBBON
DIRECTION
SHIFT
OFFSET
BITMAP
REVERSE
CLS
PRINT
Description
This command defines the label width and length.
This command sets the height of the black line and the user-defined
extra label feeding length each form feed takes.
This command prints 1D barcodes.
This command prints QR code.
Defines the gap distance between two labels.
This command defines the reference point of the label.
This command defines the print speed.
This command sets the printing darkness.
This setting is used to enable/disable the self-peeling function. The
default setting for this function is off.
This setting activates or deactivates the cutter and defines how many
printed labels is to be cut at one time.
This setting activates or deactivates the cutter and defines how many
printed labels is to be cut at one time.
This command is used to enable/disable feeding of labels to gap/black
mark position for tearing off.
This setting is used to enable/disable ribbon sensor detection.
This command defines the printout direction.
This command moves the label's vertical position.
This command defines the selective, extra label feeding length each
form feed takes, which, especially in peel-off mode and cutter mode, is
used to adjust label stop position, so as for label to register at proper
places for the intended purposes. The printer back tracks the extra
feeding length before the next run of printing.
This command draws bitmap images.
This command reverses a region in image buffer.
This command clears the image buffer.
This command prints the label format currently stored in the image
buffer.
76
User Guide V1.0