Table of Contents
Advertisement
Figure 64. Installing an expansion card into a low profile left riser
Figure 65. Installing an expansion card into a low profile right riser
Next steps
1. If applicable, connect the cables to the expansion card.
2.
Install the air
shroud.
3. Follow the procedure listed in
4. Install any device drivers required for the card as described in the documentation for the card.
NOTE:
While replacing faulty storage controller/FC/NIC card with the same type of card, after you power on the system;
the new card automatically updates to the same firmware and configuration of the faulty one. For more information about
the Part replacement configuration, see the Lifecycle Controller User's Guide at
70
Installing and removing system components
After working inside your
system.
https://www.dell.com/idracmanuals
Advertisement
Table of Contents
