Warning; Machinery General Safety Warnings - Jet 414500 Operating Instructions And Parts Manual

Warning

- Misuse of this machine can cause serious
injury.
- For safety, machine must be set up, used and
serviced properly.
- Read, understand and follow instructions in
the Operating Instructions and Parts Manual
which was shipped with your machine.
When setting up machine:
- Always avoid using machine in damp or
poorly lighted work areas.
- Always be sure the machine support is
securely anchored to the floor or the work
bench.
When using machine:
- Always wear safety glasses with side shields
(See ANSI Z87.1)
- Never wear loose clothing or jewelry.
- Never overreach—you may slip and fall.

Machinery General Safety Warnings

1. KEEP GUARDS IN PLACE and in working
order.
2. REMOVE ADJUSTING
WRENCHES. Form habit of checking to see
that keys and adjusting wrenches are removed
from tool before turning it on.
3. KEEP WORK AREA CLEAN. Cluttered areas
and benches invite accidents.
4. DON'T USE
ENVIRONMENT. Don't use power tools in
damp or wet locations, or expose them to rain.
Keep work area well lighted.
5. KEEP CHILDREN AWAY. All visitors should
be kept a safe distance from work area.
6. MAKE WORKSHOP
padlocks, master switches, or by removing
starter keys.
7. DON'T FORCE TOOL It will do the job better
and safer at the rate for which it was designed.
8. USE RIGHT TOOL Don't force tool or
attachment to do a job for which it was not
designed.
9. USE PROPER EXTENSION CORD. Make
sure your extension cord is in good condition.
When using an extension cord, be sure to use
one heavy enough to carry the current your
product will draw. An under-sized cord will
cause a drop in line voltage resulting in loss of
KEYS AND
IN DANGEROUS
KID PROOF with
When servicing machine:
- Always disconnect the machine from its
electrical supply while servicing.
- Always follow instructions
Instructions and Parts Manual when changing
accessory tools or parts.
- Never modify the machine without consulting
JET Tools.
You—the stationary power tool user—hold the
key to safety.
Read and follow these simple rules for best results
and full benefits from your machine. Used properly,
JET machinery is among the best in design and
safety. However, any machine used improperly can
be rendered inefficient and unsafe. It is absolutely
mandatory that those who use our products be
properly trained in how to use them correctly. They
should read and understand the Operating
Instructions and Parts Manual as well as all labels
affixed to the machine. Failure in following all of
these warnings can cause serious injuries.
power and overheating. Table 1 shows the
correct size to use depending on cord length
and name-plate ampere rating. If in doubt, use
the next heavier gage. The smaller the gage
number, the heavier the cord.
10. WEAR PROPER APPAREL Do not wear loose
clothing, gloves, neckties, rings, bracelets, or
other jewelry which may get caught in moving
parts. Non-slip footwear is recommended.
Wear protective hair covering to contain long
hair.
11. WEAR EYE PROTECTION. Always use safety
glasses. Also use face or dust mask if cutting
operation is dusty. Everyday eyeglasses only
have impact resistant lenses, they are NOT
safety glasses.
12. SECURE WORK. Use clamps or a vise to hold
work when practical. It's safer than using your
hand and it frees both hands to operate tool.
13. DON'T OVERREACH. Keep proper footing
and balance at all times.
14. MAINTAIN TOOLS WITH CARE. Keep tools
sharp and clean
performance. Follow instructions for lubricating
and changing accessories.
15. DISCONNECT TOOLS before servicing; when
changing accessories, such as blades, bits,
cutters, and the like.
in Operating
for best and safest