Switching On And Off - Black & Decker BDH2010LP Instruction Manual

• Take the appliance and the charger to be tested at an
authorized service facility.
Note: It may take as long as 60 minutes to determine
that the battery is defective. If the battery is too hot or
too cold, the LED will alternately blink, fast and slow,
one flash at each speed and repeat.
Wall Mounting (BDH2010LP)
The product can be wall mounted, if desired, using the
wall mount bracket, screws and anchors supplied. To wall
mount the vac, refer to figures B and C.
• Figure B - Mark the location of the screw holes.
• Figure C - Hang the vac on the wall by placing the opening on the
base of the vac over the hooks in the wall mount bracket.
Use

Switching on and off

• Figure D - To start, slide the On/Off switch forward (i.e. "O"= Off, "I" = On).
• To stop, slide the switch back.
• Return the product to the charger immediately after use so that it will be
ready and fully charged for the next use. Ensure that the product is fully
engaged with the charger base.
Cleaning and emptying the product
WARNING:
Respiratory Hazard: Never use the vac without
its filter.
NOTE: The filter is re-usable, do not confuse
it with a disposable dust bag, and do not throw
it away when the product is emptied. We
recommend that you replace the filter every 6-9
months depending on frequency of use.
There are two methods of cleaning the bowl, a
quick empty method and a thorough clean method.
For a quick empty (figures E, F)
• Figure E - Press in on both nozzle release buttons on
the sides of the nozzle and remove the nozzle by pulling
straight off.
• Figure F - Empty the dust from the bowl.
• For a more thorough cleaning, remove bowl as described
in figures G, H, & I.
Projectile/
5
B
D
E
F
C