Advertisement
Step 7
You will need:
28 x Plastic Slat Caps
(P13)
14 x Center Plastic
Slat Caps
(P14)
Push 2 x Slat Caps (P13), 2 Slats (P15) and 1 x Centre
Plastic Slat Caps (P14) together. Lower the fully assembled slat
into side rails (P5). Ensure the connectors are in place over the
side rail holes and apply down ward pressure on the slat with
the end connectors until the end plastic cap is fully inserted into the rail.
Repeat for all 13 Slats.
Step 8
IMPORTANT: Fully tighten all bolts on bed. Periodically check to ensure all bolts remain tight.
In the interest of our environment please dispose of all packaging thoughtfully.
fantasticfurniture.com.au
(P13)
Job Complete!
(P15)
(P14)
(P8)
(P15)
(P5)
(P5)
Page 8
(P13)
Advertisement
