Maintenance; Cleaning Filters; Replacement Filters - Shark HZ500ANZ Series Instructions Manual

MAINTENANCE

IMPORTANT: Unplug the vacuum before performing any maintenance.
EMPTYING THE DUST CUP
Empty the dust cup each time you vacuum and periodically during cleaning, if debris in the
dust cup reaches the MAX fill line.
Press the wand release button and lift the
handheld vacuum off the wand.
Empty
Empty
Button
Hold the dust cup over the bin. Press the
Empty button and pull the dust cup open.
10 AU sharkclean.com.au NZ sharkclean.co.nz
Release
Button
To remove the dust cup from the handheld
vacuum, squeeze the two Dust Cup Release
buttons at the same time and pull out the dust
cup.
To reinsert the dust cup back into the
handheld vacuum, angle the tip first and then
push up until it clicks into place.
MAINTENANCE
IMPORTANT: Unplug the vacuum before performing any maintenance.

CLEANING FILTERS

Perform regular maintenance on the filters to keep your vacuum's suction power optimal.
IMPORTANT: To prevent damage, rinse filters with water ONLY. DO NOT use soap. Allow filters
to air-dry for at least 24 hours before reinstalling them to prevent liquid from being drawn into
electric parts.
Pre-Motor
Filters
Release
Button
PRE-MOTOR FILTERS
To access the pre-motor filters, press and
pull both filter access tabs on the dust cup
to remove the filter holder. The Pre-Motor
Filters should be washed twice a month.

REPLACEMENT FILTERS

NOTE: For replacement filters please visit
Release
Button
Post-Motor Filter
Access
POST-MOTOR FILTER
Remove the filter cover on the top of the
handheld vacuum to access the post-motor
filter. The Post-Motor Filter should be
washed once every 9 months.
AU sharkclean.com.au NZ sharkclean.co.nz
AU 02 8801 7666 NZ 0800 112 660 11