Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Shark S3501C
Summary of Contents for Shark S3501C
- Page 1 OWNER’S GUIDE S3501C...
-
Page 2: Important Safety Instructions
IMPORTANT SAFETY INSTRUCTIONS SAVE THESE INSTRUCTIONS For Household Use Only WHEN USING YOUR SHARK 1. Use the system only for its intended use. STEAM MOP, BASIC SAFETY 2. DO NOT use outdoors. PRECAUTIONS SHOULD 3. DO NOT leave the appliance ALWAYS BE FOLLOWED, unattended when plugged in. INCLUDING THE FOLLOWING: Always unplug the power cord from the electrical outlet when not READ ALL INSTRUCTIONS in use and before servicing. -
Page 3: Quick Start
Quick Start When assembling your steam mop there may be a little water in or around the water tank. This is because we test all our steam mops 100% before you buy them, so you get a quality Shark Steam Mop. ® ASSEMBLE 1 Insert the mop handle into the pump actuator (the tube that leads to the tank). Push the mop handle and pump actuator together in FILL until you hear it click into place. 4 Lay the mop on the floor or on a counter top and remove the 2 Select a mop head and cleaning water tank cap by turning counter pad. Fit one side of the pocket clockwise. Fill the water tank using onto the head first, then using the filling flask. Do not overfill the the lavender loop, pull the pocket water tank. Replace the water cap over the head. Attach the quick and tighten. fasteners on the top of the pocket to secure in place. IMPORTANT: Make sure your floors are sealed. Before using the Steam 3 Snap the mop head into the base to Mop consult page 3 for more secure it. Press the release button... -
Page 4: Table Of Contents
TECHNICAL SPECIFICATIONS Voltage: 120V., 60Hz. Power: 1550 Watts Water Capacity: 450 ml (15 oz.) TOLL FREE: 1-866-826-6941 Contents Thank you for Getting Started ... 2 purchasing Using Your Steam Mop ... 5 the Shark ® Using Your Carpet Glider ... 7 Steam Pocket Care of Your Steam Mop ... 8 Mop. Ordering Replacement Parts ..10 Troubleshooting Guide ...11 Warranty and Registration ...13 English www.sharkcompany.com... -
Page 5: Getting Started
Getting Started When assembling your steam mop there may be a little water in or around the water tank. This is because we test all our steam mops 100% before you buy them, so you get a quality Shark ® Steam Pocket Mop. a Rectangle Cleaning Pad j Quick Release Swivel Cord Wrap b Steam Duster Pad k Cord Clips c Triangle Cleaning Pad l Mop Handle d XL Rectangle Cleaning Pad m Telescopic Handle Latch e Carpet Glider n Water Tank Viewing Window f Filling Flask o Power-On Blue Light (Lights up when plugged-in) g Triangle Mop Head p Water Tank Cap h Rectangle Mop Head i XL Rectangle Mop head... -
Page 6: Using Your Steam Mop
Getting Started - cont’d IMPORTANT: First things first, always make sure the mop is UNPLUGGED from the wall when not in use. Never fill the mop, attach the mop head, change or remove the micro-fiber pocket when the mop is plugged into the wall. If you have hard water you might want to use distilled water to prolong the life of the Shark Steam ® Mop. Make sure you only add water to the tank. Chemicals or cleaning solution may damage the appliance and could be unsafe for you and your family. attach the quick fasteners on the 1 Turn the water tank cap counter clockwise and remove from the tank. top of the pocket to secure in place. You can also use the loop to pull the Use the filling flask and pour water dirty pocket off when you are done into the tank. Please don’t overfill. mopping after it has cooled. Replace the cap on the water tank by 3 Snap the mop head into the base to turning clockwise and tightening. secure it. 2 Select a mop head and cleaning IMPORTANT: Don’t use on unsealed pad. Each mop head can be used wood or unglazed ceramic floors. -
Page 7: Using Your Carpet Glider
Using Your Steam Mop - cont’d 3 For your comfort, you can adjust the 5 When the water tank is empty, the height of the mop. Just lift the latch steam mop will stop producing on the tube 90 degrees to the open steam. You can refill the water tank position. Holding the handle, extend at any time as long as the mop is the tube to the height that’s right for unplugged from the outlet. Follow you and then close latch to locked the instructions from page 3. This position. goes for switching the mop heads or micro-fiber pockets as well. 4 When one side of the micro-fiber pocket gets dirty, just flip the mop IMPORTANT: Never leave the steam head and you can quickly start using mop with a damp/wet micro-fiber the other side. Dirt can’t hide on pocket on any floor surface for any either side. amount of time as this may damage the floor. IMPORTANT: Please wait 3-5 minutes for the Steam Mop to cool off before switching the mop head or the micro-fiber pockets. TOLL FREE: 1-866-826-6941 Using Your Carpet Glider The Steam Mop won’t clean your carpeting or area... -
Page 8: Care Of Your Steam Mop
Care of Your Steam Mop AFTER USE AND STORAGE 1 When you have finished using the steam mop, and your floors are clean, unplug the cord from the outlet and move it into an upright position. Let the unit cool 2-3 minutes and release steam by pumping the handle several times before removing the micro-fiber cleaning pocket from the mop head. 3 To store the Shark Remove the micro-fiber cleaning pocket by releasing the quick hanging up; first remove the head fasteners and using the lavender (after it has cooled and the steam loop on the side of the pocket, has been released) then hang on a avoiding contact with the hot pocket large hook. or dirt. Then empty the water tank. NOTE: If you want to store it IMPORTANT: Be very careful standing upright then make sure because the cleaning pockets can it’s leaning against a wall for added get very hot from the steam, so use support and safety. Always store caution when removing them. Let your Steam Mop with the micro-fiber the unit cool 2-3 minutes. -
Page 9: Ordering Replacement Parts
Ordering Replacement Parts ORDERING REPLACEMENT PARTS PART To order additional parts and 1 3 All-Purpose accessories, feel free to contact us at Cleaning Pads www.sharkcompany.com or call 1-66-26-641. 2 2 Steam Duster Cleaning Pads 3 Rectangle Mop Head 4 XL Rectangle Mop Head 5 Triangle Mop Head 6 Carpet Glider TOLL FREE: 1-866-826-6941 Troubleshooting Guide PROBLEM The Steam Mop will not turn on. Steam Mop will not make steam. Steam Mop leaves water on the floor. - Page 10 SERVICE”. We are constantly striving to improve our products, therefore the specifications contained herein are subject to change without notice. OWNERSHIP REGISTRATION CARD FOR CANADIAN CONSUMERS ONLY Please complete and return within ten (10) days of purchase. The registration will enable us to contact you in the event a product defect is discovered. By returning this card you acknowledge to have read and understood the instructions for use, and warnings set forth in the accompanying instructions. RETURN TO: EURO-PRO Operating LLC, 4400 Bois Franc, St. Laurent, Quebec H4S 1A7 PURCHASER: ……………………………………………………………………………………………... ADDRESS: ………………………………………………………………………………………………... S3501C DATE OF PURCHASE: …………………….. MODEL: ………………... NAME AND ADDRESS OF STORE: ………………………………………………………………….. TOLL FREE: 1-866-826-6941 www.sharkcompany.com...
- Page 11 Canada: EURO-PRO Operating LLC 4400 Bois Franc Ville St. Laurent, Québec H4S 1A7 U.S.: EURO-PRO Operating LLC Boston, MA 02465 1-866-842-6941 www.sharkcompany.com COPYRIGHT© EURO-PRO OPERATING LLC 2009 PRINTED IN CHINA REV. 090414 Illustrations may differ with actual product.