Start Cycle; Daily Care; Stop Cycle; Service Problems - Proluxe CS157 Operation Manual

Vantage light - single lid clamshell grill
Table of Contents

Advertisement

your right control settings. If you desire a 
separate left timer you can manually adjust 
the left side timer without affecting the right 
timer. 
 
 
C L E A N C Y C L E 
 

Start Cycle

 
To start a clean cycle, push CLEAN button 
once so the CLEAN LED light is turned on. All 
preset LED's are turned off, and the 
temperature set point is changed to the clean 
set point of 275°F. This also initiates the cool 
down to clean set point condition as well the 
display starts flashing until the clean set 
point is reached. 
 
Stop Cycle 
To stop the clean cycle, simply press the 
CLEAN button once to deactivate the clean 
cycle. The CLEAN LED is turned off, the 
preset LED's are restored, the temperature 
set point is changed to the main set point. 
Again, the warm-up condition is initiated and 
the display flashes until the cook set point is 
reached. 
 
Change Clean Temp
275°F is the factory default temp for the 
CLEAN cycle. To change the CLEAN cycle 
temp, simultaneously hold down the TEMP 
and CLEAN buttons for 15 seconds. The 
current temp setting will display on the right 
digital display only. Using the up or down 
arrows to adjust to the desired temp. 
 
 
P R E V E N T A T I V E   
M A I N T E N A N C E   
 
 
Proluxe machines are relatively 
maintenance-free. For a long lifespan, the 
following preventative maintenance should 
be followed: 
 
Daily Care: 
1.​ Platens:​ Turn your machine off and allow 
to cool down before attempting to clean. 
These platens should only be cleaned with 
mild soap and warm water then wiped off 
with a clean, soft cloth or soft sponge.  
 
2. ​ E xterior surfaces:​ Wipe daily with mild 
soap and warm water. 
 
DO NOT use ice or cold water to cool the 
unit down. This can cause platens to warp. 
 
Service Problems: 
Contact our factory at (800) 624-6717 (U.S. 
only) or approved service agency. When 
contacting the factory for information, parts 
or service instructions, please provide the 
serial number of the machine be provided. 
This number can be found on the serial plate 
located on the rear of the machine. 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

Advertisement

Table of Contents
loading

Table of Contents