Attaching The Sensors - Noraxon myoMOTION System Quick Start Manual

myoMOTION Quick Start Guide
Step 2
Select the myoMOTION icon, within the 'New Device
column, and click on the Insert Insert Insert button. Insert
Make sure the Receiver is attached to the USB port of
the computer.
Step 3
The myoMOTION Settings dialog will appear as shown.
Input the serial numbers of your myoMOTION IMUs into
Body Model Sensors list according to the locations you
will put the sensors on the body.
Step 4
Within the Device Settings Device Settings Device Settings Device Settings tab, select the desired
collection Sampling Rate.
Select a RF network from the RF network list. In most
cases, the default "A" will work. However, if using
multiple myoMOTION systems, each system must be
placed on separate networks to avoid interference that
may cause data loss or other issues.
If using MyoSync, check the Use Noraxon MyoSync
checkbox.
Check Accel. Data Accel. Data if you wish to include acceleration Accel. Data Accel. Data
data in your measurement.
Select Ok Ok Ok when finished. Ok

5 Attaching the Sensors

Before performing a recording, decide which body segments will be included in the recording. The sensors can be attached
with the provided fixation straps. For fast or impact related movements, we recommend additional fixation of the sensors
with the use of elastic self-adhesive tape.
Sensor configuration, placement, and fixation best practices are further detailed and explained in the myoMOTION
Hardware User Manual. What is listed here is only a summary.
(Rev B)
'New Device' ' ' '
'New Device 'New Device
5