Table of Contents
Advertisement
myoMOTION Quick Start Guide
3 Installing the Companion Software - myoResearch™ 3
To utilize the full functionality of the Ultium EMG system, and ensure the system has updated drivers, Noraxon's
myoResearch 3 needs to be installed on the computer.
The myoMOTION Receiver requires the Noraxon USB device driver which is pre-installed by the MR3 software installation.
It is also available in the
Downloads Section
3.1 Software Installation
Within the package the myoMOTION System was shipped in, there is a
USB flash drive containing the latest myoResearch 3 software.
1. Insert the MR3 USB flash drive into the PC
2. A menu will automatically pop up
3. Click on the Noraxon installation file and follow the Wizard's
instructions
3.2 Activating the Software
The installed companion software must be activated before unrestricted use is possible.
1. Open MR3
2. A dialog box will indicate how many more times MR3 can be
opened
3. Click on "Activate"
4. Enter the License ID provided on your USB flash drive and
press "OK"
5. If you have an internet connection, click Activate by Internet
for immediate activation
6. Alternatively, email the provided activation ID to
activation@Noraxon.com
respond by phone with the Activation Code. Enter the
provided Activation Code to remove any restrictions on use.
4 Configuring the Hardware
Before the myoMOTION system can be used, the device software settings must be configured to recognize the different
components that make up the system. Follow the below instructions to update the receiver firmware, sensor firmware, and
populate sensors to prepare for a data collection.
Step 1
Open MR3, typically listed under Noraxon -> MR3
Click on the Hardware Setup
Hardware Setup button in the upper right-hand
Hardware Setup
Hardware Setup
corner.
(Rev B)
of the Noraxon website.
Noraxon Support will email or
4
Advertisement
Table of Contents
