General Information; Explanation Of Words - BWT PERMAQ COMPACT 270 Series Installation And Operating Manual

UK
1.

GENERAL INFORMATION

This installation and operating
manual applies to
®
PERMAQ Compact
total desalination plant.
This installation and operating
manual contains important infor-
mation about the correct installa-
tion and operation of the BWT
PERMAQ ® Compact plant which
is why the following is very im-
portant.
1. Enclosed "Start-up test"-
(section 13.4) shall be
completed and filed to-
gether with the operating
journal.
2. Operating journal shall be
updated as described in
"Operating journal" (sec-
tion 13.5).
3. Floor drain must be avail-
able in the immediate vi-
cinity of the plant.
4. The BWT PERMAQ
pact plant removes more
than 98 % of all salts, and
that is why you need to be
alert to possible
treatment with mixed bed
or similar, if a better wa-
ter quality is requested.
5. The authorised
takes on full responsibility
without costs
who, however, grants a
12 months guarantee in-
clusive of replacement of
defective spare parts, on
condition that the parts
are returned to BWT along
with a specification of the
fault and stating produc-
tion month /year (plant
no.).
6. The warranty becomes in-
valid, if the plant is not
commissioned by an au-
thorised BWT service tech-
nician.
7. The warranty becomes in-
valid, if maintenance in-
tervals are not met.
4
This instruction should be read
carefully before installing and
starting up the plant. Correct
installation and operation will
BWT
also form the basis of a possible
271-274
factory warranty.
Your BWT PERMAQ
plant is a compact design with
reservoir
PERMAQ
together in order to take up a little
space as possible.
The BWT PERMAQ
plant with its compact and fin-
ished design is easy to install,
since all installations are pre-
assembled and tested in our fac-
tory.
Your BWT PERMAQ
plant is equipped with casters and
constructed in a stainless steel
frame. That means that the plant
can be placed e.g. underneath a
table and then pulled out for a
service check.
Your BWT PERMAQ
®
Com-
plant is equipped with a powerful
transport pump which supplies
water at a pressure flow as the
normal
post-
sure/flow.
Your BWT PERMAQ
plant is designed for a minimum
of service and for long and un-
agent
problematic operation. However,
this is on condition of correct
for BWT
installation and maintenance.
Always read this manual careful-
ly before commissioning.
2. EXPLANATION OF
WORDS
There will be a few technical ex-
planations
which we explain below.
Permeate:
®
Compact
tank and BWT
® Compact plant built
® Compact
® Compact
®
Compact
waterworks pres-
® Compact
in this instruction
The treated, totally
desalinated water
which is produced
by the BWT
PERMAQ ® Compact
plant and supplied
to the reservoir tank.
Concentrate: Is the water that is
led to outlet. This
water contains the
salts and minerals
that have been re-
moved from the wa-
ter.
Raw water: Is the water which is
led directly to the
BWT
Compact plant and
which must be de-
salinated in the BWT
PERMAQ
plant.
TDS: The amount
totally
salts, measured in
(mg/l).
Conductivity: Is the designation of
salt concentration of
the water, measured
in (µS/cm).
lower the value, the
better
quality.
Membranes: Is the filter of the
plant which by high
pressure and flow is
capable of desali-
nating the raw wa-
ter.
RO: The abbreviation for
Reverse Osmosis.
Transport- Is the pump which
pump: transports
treated water from
the plant reservoir to
the consumer.
Level switch: Is a switch, which
gives a signal when
the BWT PERMAQ
Compact plant must
either be started or
stopped, and it stops
the transport pump
in case
running of the reser-
voir tank.
Softening Is a pre-filter which
plant: softens the water,
that means it re-
moves
from the water.
PERMAQ ®
® Compact
of
dissolved
The
the water
the
®
of dry-
hardness