Current SILENT TRAC Installation Manual page 3

4. Style the Returns
Most fascia styles allow for returns to be bent in either a rounded or
angled manner in the field. By hand, gently bend the fascia ends into
the desired shape. See Figure 4.
For hard bends, we recommend removing the fascia from the clips,
then using a flat surface like a table to help bend the fascia.
Figure 4 - Bend return into desired shape
5. Check for levelness
Note the levelness of the fascia. It may be necessary to attach the
fascia to the wall with removable VHB tape to hold fascia at the
correct level.
II. Removing a Fascia Clip
1. Pop out the back of the clip
To remove a clip, begin by inserting a flat head screwdriver into the
pocket at the back of the track.
Angle the screwdriver towards the window to apply pressure to the
bottom of the fascia clip. The back of the clip should pop out of the
track groove. See Figure 5.
Figure 5 - Pop the back of the clip from the track
2. Pop out the front of the clip
After the back of the clip has been popped out of the track, apply
slight pressure to the front of the clip to dislodge the feature from
the track groove. See Figure 6.
Use a rolling motion to remove the clip from the track.
Figure 6- Pop the front of the clip from the track
3