Current SILENT TRAC Installation Manual page 2

1. Install the Clips
On ceiling mount installations, confirm the fascia clips are already
installed on the track drapery, then proceed to step 2.
On wall mounted track installations, snap the fascia clips into the
recess at the top of the drapery track, one side at a time. Use a fascia
clip between each set of brackets. Clips snap into the top track by
hooking onto the front lip of the top of the track and then pressing
down on the back. See Figure 1.
Install the center clip first, then install clips on each end of the track.
Install a clip every 16"-24". Space outer fascia mounting clips as
close to outside brakets as possible.
2. Snap on the Fascia
Orient the fascia so the protrusion is at the top. Starting in the
middle, snap the protruding feature of the fascia into the "U" shaped
clips until it snaps. Starting from the center and moving outward,
snap fascia onto the clips. For larger installs, it may require two
people to install the fascia.
Snap the protrusion into all the remaining clips. Be sure the fascia
is positioned where desired, with the proper amount of fascia left
on each side of the track. See Figure 2.
3. Adjust Fascia Angle
If desired, on fascias 3" and above, the angle of the fascia can be
adjusted by using a phillips head screwdriver to pivot the angle of
the clip mouth. Be sure to adjust the angle on all clips to create a
uniform look. See Figure 3.
I. Install the Fascia
2
Figure 1 - Snap in fascia clips
Figure 2 - Snap fascia protrusion into clips
Figure 3 - Adjust fascia angle if desired