Changing Custom User Settings; Restoring Factory Default Settings - Anvil MWA1400 Installation, Operation And Care Manual

CHANGING CUSTOM USER SETTINGS

Before entering Custom User Settings mode ensure any current cooking cycle that may still
be incomplete is allowed to finish or cancelled by pushing the STOP/CLEAR button.
Then follow the sequence below.
1. Open the oven door, then press and hold button number 2 for 5 seconds.
(The oven will beep once and display "OP:—").
2. Using numbers 1 to 0, enter the Option Number shown in the table on page 9 that
matches the desired user setting (The oven will display the current selection).
3. Continue pressing the same number button selected above in step 2 to scroll through
the display settings until the desired option is reached.
4. Press START/+10 SEC to save the chosen setting. (The oven will display "OP:—).
5. Press STOP/CLEAR and close the oven door.
Example; To change the BEEP volume to low. (Custom User Option Setting Number OP:21)
1. Open the oven door, then press and hold number button 2 for 5 seconds. (The oven will
beep once and display the current selection)
2. Press number 2 repeatedly to scroll through the display settings until the desired option
is shown (OP:21), ie; OP:23 > OP:20 > OP:21
3. Press START/+10 SEC button. (Oven will display "OP:—" )
4. Press STOP/CLEAR and close the oven door.

RESTORING FACTORY DEFAULT SETTINGS

To return the oven to its original default settings follow the following sequence.
1. Open and close the oven door. The display will then show "READY"
2. Press and hold the START/+10 SEC button and 0 simultaneously for 10 seconds.
10