Instant Start Heating; Manual Heating; Multi-Stage Cooking - Anvil MWA1400 Installation, Operation And Care Manual

INSTANT START HEATING

1. Open the door and position food in the oven. Close the door. The oven display will show
"READY".
2. Press the START/+10SEC button to begin heating for 10 seconds at 100% power*.
3. Continue pressing the START/+10SEC button to increase the heating time by 10 second
increments until the required heating time is reached.
*Instant Start Heating operates at 100% power only.

MANUAL HEATING

1. Open the door and position food in the oven. Close the door. The oven display will show
"READY".
2. Enter the heating time required by pressing the TIME button followed by the time
required using buttons 1-0. (The maximum heating time possible is 60 minutes).
3. Select the desired oven power level by pressing 0%, 20%, 50% or 70% POWER
buttons. (If no power level is selected the oven will operate automatically at 100%
power.) If the incorrect power level has been selected press the incorrect power level
button again to clear the chosen power level.
4. Press START/+10 SEC to begin heating.
(Heating can be paused at any time by pressing the STOP/CLEAR button once. To resume
heating press the START/+10SEC button. To stop the heating cycle and clear the remaining
time press the STOP/CLEAR button twice.)

MULTI-STAGE COOKING

Multi-Stage function assists heating/cooking of dense or frozen foods such as lasagne that
are difficult to achieve with single stage heating/cooking. Multi-Stage cooking/heating can be
used either manually or within a Preset Memory (Page 8).
Stage 1
1. Open the oven door and place food in the oven. Close the door. The oven display will
show "READY".
2. Press the TIME button and then using buttons 1-0 enter the required heating time for the
first stage.
3. Select the required power level 0%, 20%, 50% or 70%. Alternatively skip this step to
select 100% power.
Stage 2 & 3
4. Press the TIME button and using buttons 1-0 enter the required heating time for Stage 2.
5. Select the required power level for Stage 2, 0%, 20%, 50% or 70%. Alternatively skip
this step to select 100% power.
6. Repeat steps 4 & 5 if Stage 3 is required. Otherwise press START/+10SEC button to
commence heating.
(Heating can be paused at any time during Multi-Stage Heating by pressing the STOP/
CLEAR button once. To resume heating press the START/+10SEC button. To stop the
heating cycle and clear the remaining time press the STOP/CLEAR button twice.)
6