Electric Installation - 2N LiftGate User Manual

2.3 Electric Installation

®
To put 2N LiftGate
external antenna and insert 1 SIM card at least. The main unit is powered by 100–230 V
mains voltage.
B a t t e r y
Loosen the two screws on the main unit upper cover. Slide the upper cover upwards
for lift-up and removal from the holding profiles. Proceed with caution minding the
grounding wire connecting the cover with the bottom part of the main unit. Do not
disconnect the wire unless necessary! Insert the battery pack with the connectors
directed upwards on the right-hand side. Interconnect the fitted battery pack with the
motherboard using a Faston cable respecting the required polarity.
Caution
Maintain the battery pack polarity.
In the case of the battery polarity reversal,
with a relay to be hazard-free.
Replace the upper cover to the main unit and tighten the fixing screws. Make sure that
the grounding wire is connected with the cover while replacing the cover!
S I M
Insert the SIM card in any SIM slot on the right side of the device.
A n t e n n a
Screw the enclosed antenna into the SMA antenna connector. Tighten the antenna
connector gently with your hand, never use a wrench.
P o w e r
Plug the power cable socket into the electric power source.
2N TELEKOMUNIKACE a.s., www.2n.cz
in operation, connect the device to the power supply, connect an
p a c k
c a r d
s u p p l y
i n s t a l l a t i o n
®
2N LiftGate is protected
i n s t a l l a t i o n
c o n n e c t i o n
c o n n e c t i o n
20/82