Receiver Settings; Half-Rack Receiver; (Zrx-Hr50) - Sony DWZ-B50I Operating Instructions Manual

Receiver Settings

Half-Rack Receiver (ZRX-
HR50)
Use the rotary encoder and the ESC button
to configure settings on the ZRX-HR50
half-rack receiver. Perform setting
operations as follows.
Confirm: Press the rotary encoder.
Move cursor: Turn the rotary encoder.
Cancel: Press the ESC button.
Displaying the settings menu
Press the rotary encoder to display the
[Setup] screen in the display.
To return to the main screen from the
[Setup] screen, press the ESC button.
Configuring the receiving
channel settings
Two RF modes (channel modes), [Wide
Band] and [Narrow Band], are available on
the DWZ.
Each RF mode consists of six channels.
Select the appropriate channel according to
your intended use. The RF mode is set to
[Wide Band] and the transmission channel
is set to 1 under factory default settings.
14 Receiver Settings
RF mode Transmitting
channel
number
Wide Band 1/2/3/4/5/6
(WIDE)
Narrow a/b/c/d/e/f
Band
(NARROW)
Caution
When using multiple channels (up to six),
the two RF modes, [Wide Band] and
[Narrow Band], cannot be used
simultaneously. Select only one RF mode
during use. In addition, Wi-Fi and other
environmental interference may reduce the
actual number of channels that can be used
simultaneously.
To select the RF mode
1
In the [Setup] screen, select [Advanced
Settings].
2
Select [RF Mode Settings].
The [RF Mode Settings] screen
appears.
3
Select [Wide Band] or [Narrow Band].
When the configuration is complete,
the main screen appears again.
Description
This mode
reduces any
interference
to other
wireless
equipment.
This mode
uses the
Clear
Channel
Scan
function,
making it
useful for
avoiding
any
interference
from other
wireless
equipment.