Advertisement
Quick Links
Advertisement
Related Manuals for Kogan KALEDDRNYWA
Summary of Contents for Kogan KALEDDRNYWA
- Page 1 LED COLOUR CHANGING DRONE KALEDDRNYWA & KALEDDRNBLA...
- Page 3 OVERVIEW Drone B1/B2 A1/A2 Head Power Tail A1/A2 B1/B2 Note: Every propeller is marked A1/A2 or B1/B2. Ensure each propeller is installed in the correct position as shown above. Otherwise, the drone will fail to take off.
- Page 4 Transmitter Speed Setting 3D Flip One key take off/ Forward Trim Landing/ Emergency Forward/ stop (Long Press) Backwards/ Fly to Left/ Fly to Right Down/ Turn Left/ Backward trim Turn Right Left trim One key Rotation Right Trim (Short Press)/ one key spin (Long Press) Headless mode (short Press)/ Light switch...
- Page 5 SETUP Charging propellers B1/B2 A1/A2 A1/A2 B1/B2 Use the supplied screwdriver to loosen the screw by turning it counter clockwise and then remove the propeller. Install the propellers in the correct position as shown above: each propeller is marked either A1/A2 or B1/B2. Tighten the screw.
- Page 6 Charging the drone battery The drone’s battery must be charged before it can be flown. To avoid the risk of injury or damage, ensure the drone and remote control are both powered OFF and remove the battery from the drone when charging. Charging time is approximately 80-100 minutes. Charge fully before you use for best performance.
- Page 7 Flight Safety Information Maintain line of sight Fly open areas Fly below 50m Avoid flying over or near obstacles, crowds, high voltage power lines, trees, airports or bodies of water. Do not fly near strong electromagnetic sources such as power lines and those base stations as it may affect the onboard compass.
-
Page 8: Operation
OPERATION Get Your Drone Ready • Rotating propellers can be dangerous. Do not start the motor when there are people nearby. • If the motor is still engaged, always keep your hands on the transmitter. Drone Pairing Horizontal position Power on the drone and place it on a flat surface with the tail facing towards the pilot. - Page 9 Gyro Calibration After pairing, pull both control sticks down and to the right for 2-3 seconds. When you hear a beep and the lights on the drone blink rapidly for 2-3 seconds, calibration is completed. (Gyro calibration is recommended after pairing and if a crash occurs. Do not attempt to do this while flying).
- Page 10 Flight Control Rise and Fall Control Push the left control stick - up or down and the drone will ascend or descend Forward and Backward Control Push up or down on the right control stick and the drone will fly forward or backwards. Turn Left and Right Push the left control stick left or right and the drone will turn to the left or the right.
- Page 11 Left-Wing and Right-Wing Control Push the right control stick left or right and the drone will fly to the left or the right. Setting trim and Countering drift If the drone keeps drifting leftwards when hovering, press the right side-fly trimmer to adjust until it gets balanced.
- Page 12 If the drone keeps flying backwards when hovering, press the forward trimmer to adjust until it gets balanced. If the drone keeps flying forward when hovering, press the backwards trimmer to adjust until it gets balanced. Even after the drone is calibrated, it may show a tendency to drift while airborne. Adjusting the trim will help counter this effect and allow better control of the drone;...
- Page 13 Light Switch Press the light switch button to turn the lights of the drone on or off. Note: Pair the drone before pressing the light switch. One key rotation / One key spin A. One key rotation B. One key spin...
- Page 14 Short press the spin button and the drone will spin in an anticlockwise direction; short press again to exit (A). Long press the spin button and the drone will spin in circles; long press to exit (B). You can use the left control stick to adjust the height of the drone while in a spin. Note: Before you press the spin button, please make sure you fly the drone at least 8 feet away from any objects.
- Page 15 Emergency Stop (Long Press) Note: The emergency stop function should be only used in case of emergency during the flight to avoid any of damage or injury. If for any reason you need to stop the drone, press the “Emergency Stop” button or pull the left joystick down as far as it will go: the propellers will stop spinning immediately.
- Page 16 WARNING: the drone will perform these manoeuvres best with a fully charged battery. Headless Mode Note: Flying in Headless Mode without sufficient experience might result in loss or damage to the device. Do not use the Headless Mode until you totally comprehend the instructions For Use.
- Page 17 Ensure the pilot is in the same orientation as the drone head faces when the drone takes off. The pilot must not change the direction or orientation they face; otherwise, the drone and transmitter will lose connection, causing controls to not perform as desired.
- Page 18 One key return Avoid using this feature when the drone is near to the pilot, to avoid injury. Wrong Track Right Track With a press of the One Key Return button, the drone will return towards the original direction of take-off. You can rotate the right joystick in any direction to retake control of the drone and cancel the One Key Return Function.
-
Page 19: Specifications
SPECIFICATIONS Drone Flight time 10-11 minutes Operating temperature range 32° to 140°F (0° TO 40°C) Dimensions 6.3” x 6.3” x 2.95” Transmitter Operating frequency 2.4GHz Max transmission distance 200-260 feet (outdoor and unobstructed) Operating temperature 32° to 140°F (0° TO 40°C) Flight battery Capacity 800mAh... -
Page 20: Troubleshooting
TROUBLESHOOTING Problem Possible causes Solution • Check remote batteries, replace if needed. • • No power to remote Check drone battery; be or drone. sure it is fully charged. • • Poor contact Be sure the power plugs The drone does not respond between power are firmly connected. - Page 21 IN THE BOX Part Name Quantity Drone 2.4 GHz Transmitter Additional Propellers USB Charging Cable Screwdriver Battery User Guide Disposal This marking indicates that this appliance should not be disposed with other house-hold wastes. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources.
- Page 22 Need more information? We hope that this user guide has given you the assistance needed for a simple set-up. For the most up-to-date guide for your product, as well as any additional assistance you may require, head online to help.kogan.com...