Remove The Fingerprint Board - Lenovo ThinkBook 13X Hardware Maintenance Manual

"Remove the heat sink" on page 33
"Remove the golden mylar" on page 34
"Remove the USB board mylar" on page 34
"Remove the fan" on page 37
"Remove the USB board cable bracket 1" on page 35
"Remove the system board" on page 42
Step 1. Remove one screw and then remove the pen holder.
Figure 35. Remove one screw and remove the pen holder
Screw specifications
M2.0 x L3.5
Go to
https://support.lenovo.com/partslookup
part:
Pen holder

Remove the fingerprint board

Make sure the following FRUs (or CRUs) have been removed.
"Remove the lower case" on page 28
"Remove the battery pack" on page 29
"Remove the system board mylar" on page 30
"Remove the solid-state drive (SSD)" on page 30
"Remove the Wi-Fi card mylar" on page 31
"Remove the fingerprint board cable" on page 32
"Remove the heat sink" on page 33
"Remove the golden mylar" on page 34
"Remove the USB board mylar" on page 34
"Remove the fan" on page 37
"Remove the USB board cable bracket 1" on page 35
Number of screws
1
to look up the Lenovo part number of the following replacement
.
Chapter 4 Removing a FRU or CRU
47