Remove The System Board Mylar; Remove The Solid-State Drive (Ssd) - Lenovo ThinkBook 13X Hardware Maintenance Manual

Go to
https://support.lenovo.com/partslookup
part:
Battery pack

Remove the system board mylar

Make sure the following FRU (or CRU) has been removed.
"Remove the lower case" on page 28
Step 1. Disconnect the battery pack cable from the system board.
Attention: Use your fingernails to pull the connector to unplug it. Do not pull the cable.
Step 2. Peel off the system board mylar.
Figure 5. Peel off the system board mylar
Go to
https://support.lenovo.com/partslookup
part:
System board mylar

Remove the solid-state drive (SSD)

Make sure the following FRU (or CRU) has been removed.
"Remove the lower case" on page 28
Step 1. Disconnect the battery pack cable from the system board.
Attention: Use your fingernails to pull the connector to unplug it. Do not pull the cable.
Step 2. Remove one screw.
30
Hardware Maintenance Manual
to look up the Lenovo part number of the following replacement
to look up the Lenovo part number of the following replacement