Thickness Knob Adjustment (Feeding Gap); Emergency Stop Button - AccuBANKER AB4200 User Manual

4. Operation (continued)

4.3 Thickness Knob Adjustment (Feeding Gap)

If there are frequent counting errors and/or the bills do not enter the
equipment smoothly, the thickness knob needs to be adjusted.
The adjustment screw is located on the top-right corner of the unit. If the
screw is turned towards (-), the opening where bills enter the equipment from
the hopper tray narrows, making the bills run tighter. Turning the screw
toward (+) widens the gap, making the bills run more freely.
NOTE: For new bills, it is recommended to leave the gap narrow. For used
and worn bills, it is recommended to widen the gap.
a. For new (thinner) bills, adjust toward "-" to reduce the gap.
b. For used (thicker) bills, adjust toward "+" to increase the gap.
c. Small adjustments towards the "+" direction work best.
Reduce thickness gap
rotates knob toward "-"

4.4 Emergency Stop button

The emergency stop button is a safety feature that immediately stops the
equipment from performing any operations when pressed.
If the emergency button is pressed, the equipment must be turned OFF and
ON again to resume the counting operation.
0
- +
Increase thickness gap
rotates knob toward "+"
15