Table of Contents
Advertisement
4. Operation
4.1 Counting Operation
Turn on the equipment by pressing the power switch.
-
The unit will immediately proceed with a self-check routine to confirm
-
the proper functioning of its main components. If any error message is
reported, go to the Error Messages section of this guide to identify its
cause.
Select the desired detection functions MG-UV-DD (MG - UV only
-
available on models with counterfeit detection).
Set up other optional functions such as SPEED, BATCH, etc.
-
Place the bills in an orderly manner on the hopper tray and the equipment
-
will start counting automatically.
NOTE: If the unit is in MANUAL mode, press START to begin counting.
4.2 Miscounting errors
If there are continuous counting errors proceed to:
Make sure the bills are positioned neatly on the hopper tray.
-
Verify that the counting sensors are not affected by particles of dust or
-
some other nature.
Make sure that the thickness adjustment gap is in the proper position for
-
that bill (whether old, new, paper, or polymer).
If the equipment displays continuous error messages related to the MG
-
and UV functions, consider reducing the sensitivity.
14
Advertisement
Table of Contents
