Table of Contents
Advertisement
3. Getting Started
3.1 Installation
Select an appropriate workspace that is clean, flat, and leveled. The
equipment should never be placed near strong sources of light, heat sources,
or air conditioners. Please do not install the equipment where its weight
cannot be supported. Plug the power cable to the back of the unit and into the
wall power outlet.
3.2 Bill Guider Installation
1. Align the guider with the latch
mechanism in the equipment.
2. Insert the guider into the latch until it
"clicks" into position.
3. Repeat steps 1 and 2 with the other
guider.
4. To remove the guider, push it toward
you while pulling it out from the
latching mechanism.
12
Advertisement
Table of Contents
