Table of Contents
Related Manuals for Monoprice cadet
Summary of Contents for Monoprice cadet
- Page 2 1. Remove the Printer and Accessory Box from the packaging. 2. Open the Accessory Box and verify that you have all the parts listed below: 1x Platform Sticker, 1x 1.5mm Hex Wrench, 1x 2.0mm Hex Wrench 1x 2.5mm Hex Wrench, 1x Phillips Screwdriver, 1x 8mm Wrench 1x M6 Brass Nozzle, 1x MicroSD™...
- Page 3 3. Remove the eggshell carton and plastic bag from the printer, then place the printer on a table or desk. 4. Remove the cardboard block from inside the printer. 5. Insert the Filament Guide Tube into the black Pneumatic Connector on top of the Extruder.
- Page 4 6. Ensure that the power switch on the inline control on the AC Power Adapter is in the OFF position (O). Plug the DC barrel connector on the AC Power Adapter into the Power Port on the right side of the printer. Plug the included AC Power Cord into the AC Power Adapter, then plug the other end into a nearby AC power outlet.
- Page 5 9. Press the Knob to start loading filament. Once filament starts extruding from the Nozzle, press the Knob again to stop extrusion. Clean the extruded filament, then press the Knob to select the Continue option. 10. Remove the included microSD™ card from the Accessory Box, then insert it into the microSD card slot to the left of the LCD Screen.
- Page 6 Monoprice™, Cadet, the Cadet logo, and all Monoprice logos are trademarks of Monoprice Inc. microSD™ is a trademark of SD-3C, LLC. Wi-Fi® and Wi-Fi Alliance® are registered trademarks of Wi-Fi Alliance.
Need help?
Do you have a question about the cadet and is the answer not in the manual?
Questions and answers