Advertisement
5. OPERATION
WARNING! Ensure you read, understand and apply the safety instructions in Section 1 before using the heater.
‰
NOTE! The ceramic element is fragile and therefore it is important that it is not subjected to any unnecessary shocks or vibration and is
not moved when it is on or until cooled down.
5.1.
5.1.
Ensure the heater is at least 2m from any object.
5.2.
Plug in the heater and switch it on.
5.3.
When the heater is no longer required, switch off and unplug the unit.
IMPORTANT: DURING RELOCATION, THE HEATER SHOULD REMAIN SWITCHED OFF AND DISCONNECTED FROM THE POWER
SUPPLY.
WARNING! DO NOT touch the top of the heater when in use as it becomes hot.
‰
WARNING! Always allow elements to cool before moving the units. Use only on a smooth even surface. Failure to do so will cause premature
‰
wear to the lamps and reduce their working life.
5.4.
The heater has a built in tilt switch safety mechanism that switches off the unit if it is tilted beyond 25° either forwards or backwards.
This prevents fire in the event of the unit being knocked over. The unit does not turn on again when returned to the vertical. It will require
manual restart.
WARNING! DO NOT use this heater in small rooms when they are occupied by persons not capable of leaving the room on their own,
‰
unless constant supervision is provided.
5.5.
Place the heater on a level floor in the area you require to heat.
5.6.
Allow a minimum of 2m between the heater and adjacent objects.
5.7.
POWER ON/OFF
5.7.1.
Connect to mains supply turn on red rocker switch.
5.7.2.
Heater is in standby screen shows 'OF'.
5.7.3.
Press
to start heater. Screen shows: week, time, ambient
temperature and power indication.
5.7.4.
Press
again heater turns off, returns to standby screen shows 'OF'.
5.8.
SETTING TEMPERATURE
5.8.1.
Default temperature at power on is 30°C.
5.8.2.
Press
or
5.8.3.
After 5 seconds screen defaults to ambient temperature.
5.8.4.
Next setting will be based on the previous set temperature.
5.8.5.
Heater will only work when ambient is lower than the set temperature.
5.9.
SETTING POWER
5.9.1.
Heater has 3 power settings selected by pressing.
5.9.2.
POWER SETTING 1 TOP ELEMENT ON
Screen displays:
POWER SETTING 2 BOTTOM ELEMENT ON
5.9.3.
Screen displays:
POWER SETTING 3 BOTH ELEMENTS ON
5.9.4.
Screen displays:
© Jack Sealey Limited
Each element has its own switch, see fig.3.
to set temperature. One press = 1°C. Screen shows temperature only. Range is 15 to 45°C.
Original Language Version
CH30110VS Issue:1 28/07/21
Advertisement
