Advertisement
fig.1
4. OPERATION
4.1.
Connect the unit to the power supply and turn it on.
4.1.1.
The LED displays the current ambient temperature.
4.2.
TEMPERATURE CONTROL
NOTE: Temperature is displayed in degrees centigrade. To change to Fahrenheit hold both UP and DOWN arrows for 5 seconds.
4.2.1.
Switch the unit on (fig.1.5).
switched off by pressing the ON/OFF button again (fig.1.5).
4.2.2.
To set the required temperature, use the UP and DOWN arrows (fig.1.7). The temperature setting range is from 0
NOTE: If the set temperature is 2
current ambient temperature, the unit will stop working.
4.3.
CYCLE TIME CONTROL
4.3.1.
Switch the unit on (fig.1.5).
switched off by pressing the ON/OFF button again (fig.1.5).
4.3.2.
Press Temp/Time selector (fig.1.6
4.3.3.
To set ON cycle time period, use the UP and DOWN arrows (fig.1.7). Once set to the required value, stop pressing buttons and after 3
seconds the displayed value will be set.
4.3.4.
The cycle time ON value can be set from 5 minutes up to 55 minutes.
NOTE: If the inputted value exceeds 55 minutes, the unit will operate in continuous mode and displays
4.4.
TIMER
4.4.1.
To run for a set time, select the TIMER function (fig.1.9
The Timer ON indicator (fig.1.10
4.4.2.
Long press the timer button (fig.1.8
4.5.
CHILD LOCK
4.5.1.
Press the child lock button (fig.1.7
NOTE: There should be no combustible objects within 2 metres in front of the heater, within 1.5 metres of the top, and no
combustible objects or shielding objects within 0.5 metres to the left, right and rear side.
© Jack Sealey Limited
The heater will start up using the last entered values of temperature and time. The unit can be
C higher than current ambient temperature the unit will start working. If set temperature is 1
o
The heater will start up using the last entered values of temperature and time. The unit can be
) and wait a few seconds until Cycle Timer ON indicator (fig.1.3
) will illuminate.
) for 3 seconds to turn off the timer.
) for 3 seconds to turn on or turn off the child lock function.
Original Language Version
ITEM
1
LED Display for Current Temp/Set Temp-Time
2
Temperature Control Mode On
3
Cycle Time Control Mode On
4
(IR Receiver NOT FITTED TO THIS MODEL)
5
ON/OFF
6
Temp / Cycle Time Selection
7
Increase/Decrease Temp or Cycle Time Setting
8
Lock Settings - press to lock, press to unlock
9
Timer ON/OFF
10
Timer ON Indicator
11
Misfire Indicator
12
Operating Indicator
13
Fuel Gauge Display
14
Overheating Indicator
15
Tilt Indicator
16
Low/Empty fuel Indicator
17
Lock State Indicator
) and use the UP and DOWN arrows (fig.1.7) to set time.
IR13.V2, IR16.V2 Issue 1 06/04/22
DESCRIPTION
to 40
C.
o
o
o
) is illuminated.
C below
Advertisement
