Advertisement
5.10.
SETTING CURRENT DATE AND TIME
5.10.1.
After power on press
When DAY symbol (Mon to Sun) flashes, press
5.10.1.
5.10.2.
Press
again to select HOUR by pressing
5.10.3.
Press
again to select MINUTES by pressing
5.10.4.
Press
to save the date and time or wait 5 seconds without pressing the buttons and selected day and time will be saved .
5.10.5.
Repeat above procedure to reset day and time.
5.11.
SETTING DAYS OF WEEK WORKING TIME MODES
5.11.1.
Power on. Press
5.11.2.
When MON flashes select days of the week by pressing
5.11.3.
Heater has 7 daily programs and 3 working time modes can be set up within each day.
5.11.4.
Press
again and select working time modes 01, 02 03 by pressing
5.11.5.
Press
again to set the timer for power on (hours first, then minutes) by pressing
5.11.6.
Press
again to set the timer for power off. Operation is the same as above (selected using
5.11.7.
Then press
again to set temperature. Default temperature setting is 30°C.
5.11.8.
Press
again to finish the timer setting for that day. Repeat the above procedure for other days.
5.11.9.
Press
to activate or deactivate the days of week working time modes. When week and time symbols are both displayed it means
the days of week working time mode is active.
5.11.10. Repeat above procedures to change weekly working time modes timer.
5.11.11. RESET
Enter process as far as day selection then press
only reset existing programs day by day.
5.12.
OPEN WINDOW DETECTION FUNCTION
5.12.1.
When ambient temp. drops over 5°C in 10 minutes, heater will power off automatically and sound 3 alarm beeps. Power on again by
pressing
5.13.
All set programs will be stored even if the power is off.
5.14.
Temperature is only adjustable when the days of week working time modes is inactive.
5.15.
Clock continues to work after power off. Charge battery after 12 hours of initial use (standby and working modes will both charge the
battery).
6. MAINTENANCE
WARNING! Before attempting any maintenance ensure the unit is unplugged from the mains power supply, it is cool and on level
‰
ground.
DO NOT touch the element glass, even when cold.
8
DO NOT use the heater with out the grills fitted.
8
6.1.
To clean the reflector, remove the front grill by unscrewing the retaining screws and wipe the reflector with a clean dry cloth. DO NOT
use abrasives or solvents. The surface of the reflector is very soft and scratches may cause it to overheat. Replace the grille.
6.2.
To change the element remove the front grille by unscrewing the retaining screws.
6.2.1.
Ease the sprung sockets on the ends of the element back and pull the element forward so that it clears the socket, remove element.
WARNING! Never touch element glass directly with fingers, only touch the ceramic ends or use a soft cloth, to prevent damage.
‰
6.2.2.
Carefully insert the replacement lamp into the two push in side fittings with gentle pressure.
6.3.
Check the element is properly located, then replace front grill.
6.3.1.
Should the power cord require replacement, a complete wiring loom should be purchased and fitted by a suitably qualified person.
WARNING! Disconnect from the mains and allow to cool before moving or attempting any cleaning or maintenance.
‰
6.4.
Clean the heater and guard with a damp cloth and some mild detergent.
6.5.
To replace any of the elements, contact your authorised Sealey stockists.
6.6.
Use a vacuum cleaner outside the grille guard to clean dust from heater elements.
DO NOT use abrasive cleaners or polishes on casing or guard.
8
DO NOT touch the elements unless essential to do so.
8
6.7.
BATTERY REPLACEMENT
6.8.
Refer to Parts Diagram. Battery is located on the lower PCB. It is recommended that this is replaced by a suitable qualified person.
6.9.
When not in use, store the heater carefully in a safe, dry, childproof location.
© Jack Sealey Limited
for 3 seconds to set current date and time.
once to set days of the week timer.
Original Language Version
to select day.
for 3 seconds, all existing set programs for that day will be deleted. Users can
)
suitably qualified person.
CH30110VS Issue:1 28/07/21
Advertisement
