Advertisement
3.6.
THERMOSTATIC PROTECTION.
3.6.1.
The heaters have a thermal cut out to prevent the unit from overheating for any reason, especially if the air input is restricted. If the
temperature of the front grille reaches 45ºC a thermal cutout will operate, turning off the heating elements. When the fan has cooled the
unit to 40ºC, normal thermostatic operation will resume.
3.6.2.
AUTO COOLING. It is recommended that the thermostat should be set to the minimum to cool the unit prior to switching off. If the
3.6.3.
unit is switched off when operating at full temperature, and the front grille has reached 45ºC, the time delay thermostat will keep the
fan running to cool down the unit. When the front grille has cooled to 40ºC the fan will stop running.
NOTE: Auto cooling will only function if the unit is plugged into the mains and the mains is ON.
4.
OPERATION
4.1.
Position heater in an upright position on a firm and level surface and at a safe distance from any obstructions, flammable substances etc.
Keep to a minimum of 1m clearance at the front, rear and sides.
4.2.
Connect the heater to a suitable mains supply.
4.3.
Referring to either fig.6 or fig.7, set the thermostat dial to the maximum setting (fully clockwise).
4.4.
The heater will switch on when the power setting selector is set to one of the power settings.
NOTE: It will take up to three minutes for the heater to reach optimum temperature.
4.5.
Once the room reaches the required temperature, turn the thermostat dial slowly counter-clockwise until the thermostat clicks, leave the
dial in this position and the room temperature will be maintained at this setting. The heater will continue to operate until the power
switch is turned to the OFF position.
4.6.
For fan only operation, turn the power/fan selector to the fan only setting and set the thermostat to its minimum setting.
4.7.
When not in use, disconnect the heater from the mains supply. Store it in a safe, dry, childproof location.
5. MAINTENANCE
WARNING! Before attempting any maintenance, ensure that the unit is unplugged from the mains power supply and that it has cooled down.
‰
5.1.
Clean the heater with a soft dry cloth only. DO NOT use abrasives or solvents.
5.2.
Periodically check the heater grille to ensure that it is not blocked. No other maintenance is necessary. If a problem with the heater
is experienced, or if the power lead or plug is damaged, contact your local authorised service agent for repair. DO NOT dismantle or
tamper with the heater, as this may be dangerous and will invalidate the warranty.
NOTE: It may take up to three minutes for the heater elements to reach optimum temperature. This is normal and not a fault.
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
WEEE REGULATIONS
Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic Equipment
(WEEE). When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid
waste authority for recycling information.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component
parts without prior notice. Please note that other versions of this product are available. If you require documentation for alternative
versions, please email or call our technical team on technical@sealey.co.uk or 01284 757505.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
© Jack Sealey Limited
EH5001.V2 EH9001.V2
fig.6
sales@sealey.co.uk
Original Language Version
FAN
HALF
OFF
ONLY
POWER
FULL
POWER
EH15001.V2, EH9001.V2, EH5001.V2 Issue 1 01/06/23
EH15001.V2
MIN
MAX
fig.7
REGISTER YOUR
PURCHASE HERE
www.sealey.co.uk
Advertisement
