Check Operation - Frigidaire FCS388WECF Installation Instructions Manual

30" DUAL FUEL SLIDE-IN RANGE INSTALLATION INSTRUCTIONS

Check Operation

Refer to the Owner's Guide packaged with the range for
operating instructions and for care and cleaning of your
range.
Do not touch the elements or burners.
They may be hot enough to cause burns.
Remove all packaging from the oven before testing.
1. Install Burner Caps
This range is equipped with sealed burners as shown
(see Figure 9).
Figure 9
A. Unpack burner caps and trim rings.
B. Place trim rings over each burner.
C. Make sure the burner is properly aligned and
leveled. Find the recessed locating tabs under
each burner cap, and place over the white
electrode in the burner base as illustrated.
NOTE: There are no burner adjustments necessary on
this range.
Use caution when replacing the burner cap
so the electrode is not damaged.
2. Turn on Electrical Power and Open Main Shutoff
Gas Valve
(Models with an Electric Oven and a Gas Cooktop)
3. Check the Igniters
Operation of electric igniters should be checked after
range and supply line connectors have been carefully
checked for leaks and range has been connected to
electric power. To check for proper lighting:
A. Push in and turn a surface burner knob to the
LITE position. You will hear the igniter sparking.
B. The surface burner should light when gas is
available to the top burner. Each burner should
light within four (4) seconds in normal operation
after air has been purged from supply lines.
Visually check that burner has lit.
C. Once the burner lights, the control knob should
be rotated out of the LITE position.
There are separate ignition devices for each burner.
Try each knob separately until all burner valves have
been checked.
4. Adjust the "LOW" Setting of Surface Burner
Valves (see Figure 10)
A. Push in and turn each control to LITE until burner
ignites.
B. Quickly turn knob to LOWEST POSITION.
C. If burner goes out, readjust valve as follows:
Reset control to OFF. Remove the surface burner
control knob, insert a thin-bladed screw driver
into the hollow valve stem and engage the
slotted screw inside. Flame size can be increased
or decreased with the turn of the screw. Adjust
flame until you can quickly turn knob from LITE
to LOWEST POSITION without extinguishing the
flame. Flame should be as small as possible
without going out.
8
Figure 10