30" DUAL FUEL SLIDE-IN RANGE INSTALLATION INSTRUCTIONS
READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
If the information in this manual is not followed exactly, a fire or explosion may
result causing property damage, personal injury or death.
FOR YOUR SAFETY:
— Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this
or any other appliance.
— WHAT TO DO IF YOU SMELL GAS:
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use any phone in your building.
• Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's
instructions.
• If you cannot reach your gas supplier, call the fire department.
— Installation and service must be performed by a qualified installer, service agency or the
gas supplier.
Shave Raised
Edge To Clear
30" (76.2 cm)
Wide Cooktop Rim
3" Min.
(7.6 cm Min.)
1-½ " Max.
From Wall
(3.8 cm Max.)
This Side Only
30"
Locate
(76.2 cm)
Cabinet Doors
Exact
1" Min. from
G
Cut-Out
Opening
F
*Note:
29" (73.7 cm)
Wide Opening
For Overlapping
Cooktop And
Built-In Look
Grounded Junction Box
If Installing Model
Should Be Located
With Optional Side Panels,
8 " to 17" (20.3 - 43.2 cm)
Cut-Out Area Including
From right Cabinet and
Countertop Must Be At Least
2" to 4" (5.1 - 10.2 cm)
30" (76.2 cm) Wide
A. HEIGHT
3
3
35
- 36
" (90-92 cm) 30" (76.2 cm)
/
/
8
8
F. Minimum Cutout Depth is increased to 24" (61 cm) with backguard.
Recycled paper
(Models with an Electric Oven and a Gas Cooktop)
INSTALLATION AND SERVICE MUST BE PERFORMED BY
A QUALIFIED INSTALLER.
IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.
30"
(76.2 cm Min.)
30" Min.**
(76.2 cm Min.)
18" Min.
(45.7 cm Min.)
E
Approx. 1-7/8"
(4.8 cm)
(61 cm Min.)
From Floor
C. DEPTH TO
B. WIDTH
FRONT OF
RANGE
1
26
" (66.7 cm) 44
/
4
Do not pinch the power supply cord or the flexible gas conduit between the range
and the wall.
Do not seal the range to the side cabinets.
24" Min.
**NOTE: 30" (76.2 cm) minimum clearance between the cooktop and the bottom
of the cabinet when the bottom of wood or metal cabinet is protected by not less
than 1/4" (0.64 cm) flame retardant millboard covered with not less than No. 28
MSG sheet metal, 0.015" (0.4 mm) stainless steel, 0.024" (0.6 mm) aluminum,
or 0.020" (0.5 mm) copper.
36" minimum clearance when the cabinet is unprotected.
D. DEPTH
E. MINIMUM
WITH
CUTOUT
DOOR OPEN
WIDTH
7
" (114 cm)
29" (73.7 cm)
/
8
Printed in Canada
1
F. MINIMUM
G. HEIGHT
CUTOUT
OF
DEPTH
COUNTERTOP
5
21
" (55 cm)
36" (91.4 cm) standard
/
8
3
35
" (90 cm) min.
/
8
P/N 318104600 (9909) Rev. F