Panasonic NA-F100A2 Service Manual page 8

■ Make sure to ask a service person for installation. Do not install by yourself.
■ If the installation, test run and inspection of the washing machine are not carried out following this
installation method, Panasonic will not be liable for any accident or damage caused.
5.4 Connect the water tap adaptor and water supply hose.
Water faucet
Water tap adaptor
Water supply hose
CAUTION
● Tighten the nut fi rmly.
● Do not twist, squash, modify
or cut the hose.
5.5 Connect the power plug and grounding wire.
● Ask a service person to do the grounding work.
● In case of a 2-pin power cord, establish a ground.
5.6 Check the washing machine does not wobble.
■
If the washing machine wobbles
Turn the adjustable
2
leg to eliminate
wobble.
5.7 Perform a trial operation.
● Check that there is no water leakage, abnormal sounds or error display.
Service NA-F100A2.indd 8 Service NA-F100A2.indd 8
Connect the water tap adaptor to
the water faucet.
Turn part A to the left until approx.
1
4 mm of the thread becomes
visible.
2 Loosen the 4 screws.
3 Connect to the faucet and tighten
the screws.
Turn part A to the right and tighten
4
securely. (To prevent water
leakage)
Connect the water supply hose to
the water tap adaptor.
Insert the hose into the adaptor while
pushing down the lever, and hook
the claw of the lever on the fl ange of
the adaptor.
Connect the water supply hose to
the water supply valve screw.
1 Hold the elbow and tighten the nut.
Check that the elbow is not loose.
2
Turn the adjustable leg knob to
1
the left to loosen.
Turn to the right to
3
tighten.
To raise To lower
- 8 -
Screw
Part A
Flange
Thread
Claw
Lever
Nut
Elbow
Water supply
valve screw
Water supply hose
4/26/2559 BE 11:50 AM 4/26/2559 BE 11:50 AM