Makita AS001G Instruction Manual page 12

2. Place the long nozzle F over the front end of the
long nozzle R. Hand screw the long nozzle F until you
find it roughly tightened, then re-tighten it further until it
is secured with a click.
1
Fig.9
► 1 . Long nozzle F 2. Long nozzle R
3. Align the guide projections on the nozzle 13 with
the locking notches on the lock sleeve of the tool, then
push the nozzle 13 firmly into the lock sleeve until it
locks in place with a click.
5
6
Fig.10
► 1 . Guide projection 2. Locking notch 3. Lock sleeve
4. Nozzle 13 5. Long nozzle R 6. Long nozzle F
NOTE: Use the long nozzle R only to have a shorter
operating range. Use both the long nozzle R and F to
allow a wider operating range.
4. To remove the long nozzles, detach the nozzle 13
from the lock sleeve of the tool, and then disassemble
the long nozzles.
4
3
1
2
Installing and removing deflating
nozzles and attachments
Optional accessory
2
NOTICE:
Always be sure to install and uninstall
deflating nozzles and attachments only while the
air vent hose complete is disconnected from the
tool. Handling the air vent hose complete assembled
into the tool may cause the tool to stand unstable
resulting in it falling over.
1.
Align the guide projections on the pinch valve nozzle
with the locking notches on the lock sleeve of the air vent
hose complete, then push the pinch valve nozzle firmly
into the lock sleeve until it locks in place with a click.
Fig.11
► 1 . Pinch valve nozzle 2. Guide projections 3. Locking
notches 4. Lock sleeve 5. Air vent hose complete
Optional rubber attachments
Optional rubber attachments require to be placed over
the nozzle. Be careful not to attach rubber attachments
directly to the air vent hose complete.
i Align the guide projections on the nozzle 13 with
the locking notches on the lock sleeve of the air vent
hose complete, then push the nozzle firmly into the lock
sleeve until it locks in place with a click.
ii Place a rubber attachment over the nozzle head
by pushing and hand screwing it in place.
Fig.12
► 1 . Rubber attachments 2. Nozzle 13 3. Air vent hose
complete
NOTICE:
Make sure that the nozzle has been
correctly attached to the air vent hose complete
so the guide projections on the nozzle neatly fit
into the locking notches on the lock sleeve.
12 ENGLISH
5
4
3
2
3
2
1 1
1