Makita AS001G Instruction Manual page 13

NOTE: While the polished surfaces of the nozzle end
remain visible out of the lock sleeve, the nozzle is
being inappropriately placed.
Reassemble the nozzle in a correct position so the
polished surfaces of the nozzle end become invisi-
ble under the lock sleeve.
1
Fig.13
► 1 . Polished surfaces 2. Lock sleeve
2. Turn the dust cap on the suction inlet at the rear of
the housing counterclockwise to take the dust cap out
of the housing. Two locking tabs on the dust cap can be
disengaged by aligning them with the guide grooves on
the housing.
Fig.14
► 1 . Dust cap 2. Locking tabs 3. Suction inlet 4. Guide
grooves
2
1
3
2
4
13 ENGLISH
3. Attach the end of the air vent hose complete to
the suction inlet, aligning the two locking tabs on the
air vent hose complete with the guide grooves on the
housing. Then hold and turn the rear cuffs of the air vent
hose complete clockwise to secure it in place.
3
2
Fig.15
► 1 . Air vent hose complete 2. Rear cuffs 3. Suction
inlet 4. Locking tabs 5. Guide grooves
4.
To remove the deflating nozzle and attachments,
follow the installation steps in reverse.
NOTICE:
Always hold and turn the rear cuffs of
the air vent hose complete to install and uninstall
the air vent hose complete in place.
Installing optional filter
Optional accessory
An optional high performance filter (Filter C) is available for restrict-
ing dust intake into the motor under dusty working conditions.
1. Turn the dust cap on the suction inlet at the rear of
the housing counterclockwise to take the dust cap out of the
housing. Two locking tabs on the dust cap can be disengaged
by aligning them with the guide grooves on the housing.
Fig.16
► 1 . Dust cap 2. Locking tabs 3. Suction inlet 4. Guide
grooves
5
1
1
3
4
4
2