Makita AS001G Instruction Manual page 11

Removing and installing dust cap
1. Turn the dust cap on the suction inlet at the rear of
the housing counterclockwise to take the dust cap out
of the housing. Two locking tabs on the dust cap can be
disengaged by aligning them with the guide grooves on
the housing.
Fig.5
► 1 . Dust cap 2. Locking tabs 3. Suction inlet 4. Guide
grooves
2. Reassemble the dust cap onto the suction inlet,
aligning the two locking tabs on the dust cap with the
guide grooves on the housing. Then turn the dust cap
clockwise to secure it in place.
3
Fig.6
► 1 . Dust cap 2. Locking tabs 3. Suction inlet 4. Guide
grooves
1
3
4
4
1
Installing and removing long
nozzles
Optional accessory
A set of long nozzles help clean dust out of small holes
and narrow spots. Nozzle lengths can be arranged
according to your requirements.
2
Fig.7
► 1 . Nozzle 13 2. Long nozzle R 3. Long nozzle F
1.
Insert the long nozzle R through the air hole of the
nozzle 13 from back to front. Pass it though until the
nozzle 13 secures in place at the rear end of the long
nozzle R.
1
2
Fig.8
► 1 . Nozzle 13 2. Long nozzle R
11 ENGLISH
3
1
2
2